Protect Your Car
We’ve all been there - right before you lean your skis or board against that car, there’s a little voice in your head that asks “wait, is this a good idea”?
You ignore that voice and lean those sharp edges right against the shiny car paint (can you believe that this is normal?) and hope for the best. Sometimes you get lucky, but sometimes your gear comes crashing down onto the ground leaving a nasty scratch behind.
It’s loud, it’s embarrassing, it can cause expensive damage, and it’s UNNECESSARY. Don’t be that one in the parking lot. Stick a SnoStrip™ onto your ride, then gear up knowing that the only thing your skis or board edges will be cutting today is snow.
Features
4 ski grooves
4 snowboard inserts
Ski and snowboard edges fit into specialized grooves to keep them held upright and away from your car paint.
The strip comes with a long-lasting weatherproof adhesive. Peal off the protective layer, and stick it anywhere you want to lean your gear.
Installation
1. Find and clean a 1.5 in wide by 16in long area on your car for SnoStrip™.
2. Remove adhesive protector.
3. Stick SnoStrip™ onto car paint and add pressure
*SnoStrip™ will not function properly unless it is put on an exposed area that comes into contact with gear leaning against the car.
**Avoid sticking onto: chipped, dirty or wet paint, gas caps, windows or surfaces with sharp angles.
***Apply when SnoStrip™ is at room tempurature
Removal
SnoStrip™ can be used year round, but if you want to remove SnoStrip™, rest assured that the adhesive will peel off leaving NO MARKS on your car.
1. Start on a corner of SnoStrip™ and peel until the adhesive has detached from your car (use pliers if needed)
2. SLOWLY peel SnoStrip™ off
3. If you plan on re-using, cover adhesive with baking sheet or paper so that dust does not stick while in storage
Contact Us
Reach out to us by emailing Admin@SnoStrip.com.